February-19th-2021, 12:26 PM
(This post was last modified: February-19th-2021, 02:02 PM by Armin@netPI.)
Hi Carsten,
what is the netPI system software version you are running on your new netPI? Make sure you have the version v1.2.2.0 up and running first of all.
You say you can ping 192.168.1.1 which is the address of the local cifX0 ... but how about pinging the remote IP address 192.168.1.100? Does this work also?
Also interesting is which gateway addresses you have configured for eth0 and cifx0 both. It is not allowed for example to have two gateway addresses configured at the same time cause then Linux does not know where route TCP/IP frames if they are not in the pool of local addresses.
Thx
Armin
what is the netPI system software version you are running on your new netPI? Make sure you have the version v1.2.2.0 up and running first of all.
You say you can ping 192.168.1.1 which is the address of the local cifX0 ... but how about pinging the remote IP address 192.168.1.100? Does this work also?
Also interesting is which gateway addresses you have configured for eth0 and cifx0 both. It is not allowed for example to have two gateway addresses configured at the same time cause then Linux does not know where route TCP/IP frames if they are not in the pool of local addresses.
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)