October-2nd-2020, 06:55 AM
Dear Armin,
Thank you very much for your kind support.
I was able to assign the IP address to the RTE port by setting the IP address as you explained.
I was wondering if you would update this thread when you improve the procedure of setting IP address.
By the way, I can now communicate with a modbus device, which is a distributed I/O system connected to RTE port.
So, I can read/write analog signals and expand digital I/O signals from Node-RED.
https://www.contec.com/products-services...osys/nano/
Best regards,
Thank you very much for your kind support.
I was able to assign the IP address to the RTE port by setting the IP address as you explained.
I was wondering if you would update this thread when you improve the procedure of setting IP address.
By the way, I can now communicate with a modbus device, which is a distributed I/O system connected to RTE port.
So, I can read/write analog signals and expand digital I/O signals from Node-RED.
https://www.contec.com/products-services...osys/nano/
Best regards,