Accessing a modbus device connected to RTE port from Node-RED

[tad]

Dear Armin,

Thank you very much for your advice.
Even though I set FIELD = none in Env parameter area when re-deplyoed the Node-RED container 'hilschernetpi/netpi-nodered'.

So, I did the followings:
- I restored the recovery image to my netPI RTE 3, which means my netPI was initialized as the factory state.
- I enabled Docker.
- I deployed 'hilschernetpi/netpi-netx-ethernet-lan' only, with Network=host setting.
- I tried to set cifx0 IP address to both 192.168.2.169/24 and dhcp.
then,
- From my PC, I pinged 192.168.2.169, but 'Destination host unreachable' when cifx0 IP address=192.168.2.169/24.
- From my PC, I run an IP scanner software, but netPI wasn't detected when cifx0 IP address=dhcp.

Therefore, I think I may have some mistakes when 'hilschernetpi/netpi-netx-ethernet-lan' is deployed.
I attach some screen shots.
I would appreciate it if you would find something wrong.

Thank you very much for your help.
Best regards,