September-30th-2020, 02:17 AM
Dear Armin,
Thank you very much for your quick response.
Now, I set up the container of 'hilschernetpi/netpi-netx-ethernet-lan' as host.
From the edge gateway manager (Web GUI), I set the cifx0's IP address to 192.168.50.169/24.
But, 'Modbus-Write' node doesn't communicate with a modbus device connected to RTE port at all.
A status under the node indicates 'initialize'.
By the way, I have 2 containers with host settings.
Because not only 'hilschernetpi/netpi-netx-ethernet-lan' but also 'hilschernetpi/netpi-nodered' require the host setting.
Otherwise, I could not open the Node-RED editor from Chrome.
Ethernet cables are wired as follows.
PC <===> netPI std port, netPI RTE port <===> a modbus device.
If you found something wrong from the above comments, would you please give me your feedback?
Thank you very much for your support.
Thank you very much for your quick response.
Now, I set up the container of 'hilschernetpi/netpi-netx-ethernet-lan' as host.
From the edge gateway manager (Web GUI), I set the cifx0's IP address to 192.168.50.169/24.
But, 'Modbus-Write' node doesn't communicate with a modbus device connected to RTE port at all.
A status under the node indicates 'initialize'.
By the way, I have 2 containers with host settings.
Because not only 'hilschernetpi/netpi-netx-ethernet-lan' but also 'hilschernetpi/netpi-nodered' require the host setting.
Otherwise, I could not open the Node-RED editor from Chrome.
Ethernet cables are wired as follows.
PC <===> netPI std port, netPI RTE port <===> a modbus device.
If you found something wrong from the above comments, would you please give me your feedback?
Thank you very much for your support.
