June-25th-2020, 06:37 AM
Dear Armin,
I updated the firmware version of another netpi.
To come to the point, the problem also occurs for another netpi.
The details are written below.
At first, I performed firmware update with recovery usb. The info center page shows that current firmware version is V1.2.0.0. After that, in wifi dialog, I just switch to "Access point" option and then press "Change". However, the mode change did not accepted. Pre-shared key, SSID, and static IP address are required for mode change. Since, I set these parameters and press "Change". Then, set up other parameters such as dhcp server settings and push "Save". The following picture is my wifi settings.
In addition, I did not start docker service for the test.
Next, I started the test, I repowered netpi 3 times and check wifi connecting. Then, I found it that if the problem is reconstructed, I can not access to netpi without ethernet connecting. Since, I set static ip adress to eth0. The following picture is my lan settings.
Then, I continued test after changing lan settings. At sixth trial, the problem occurred. The client can connect to netpi with wifi, but ip adress is not assigned. The attached file is syslog just after the problem.
I used the same usb stick as before for making recovery usb. Is there a possibility that this usb is not compatible for netpi and it make the firmware update incompletely? The usb's generation is USB2.0, and capacity is 1GB.
Best Regards,
I updated the firmware version of another netpi.
To come to the point, the problem also occurs for another netpi.
The details are written below.
At first, I performed firmware update with recovery usb. The info center page shows that current firmware version is V1.2.0.0. After that, in wifi dialog, I just switch to "Access point" option and then press "Change". However, the mode change did not accepted. Pre-shared key, SSID, and static IP address are required for mode change. Since, I set these parameters and press "Change". Then, set up other parameters such as dhcp server settings and push "Save". The following picture is my wifi settings.
In addition, I did not start docker service for the test.
Next, I started the test, I repowered netpi 3 times and check wifi connecting. Then, I found it that if the problem is reconstructed, I can not access to netpi without ethernet connecting. Since, I set static ip adress to eth0. The following picture is my lan settings.
Then, I continued test after changing lan settings. At sixth trial, the problem occurred. The client can connect to netpi with wifi, but ip adress is not assigned. The attached file is syslog just after the problem.
I used the same usb stick as before for making recovery usb. Is there a possibility that this usb is not compatible for netpi and it make the firmware update incompletely? The usb's generation is USB2.0, and capacity is 1GB.
Best Regards,
