May-12th-2020, 08:58 PM
Hi Armin,
I have just received the new NPIX-RS485, unfortunately I cant get it to work. I am running the latest firmware on the NIOT-E-NPI3-51-EN-RE. Last night I installed the newest Docker container and set the port to /dev/ttyS0. I am running the hilschernetpi/netpi-nodered container with the new node-red 1.0.6. I have tried activating the GPIO 17 like you suggested in node-red. I get the following error “nrgpio python command not running” If I do the same setup on a raspberry PI with USB-modbus, it runs no problem. Any ideas?
Thanks
I have just received the new NPIX-RS485, unfortunately I cant get it to work. I am running the latest firmware on the NIOT-E-NPI3-51-EN-RE. Last night I installed the newest Docker container and set the port to /dev/ttyS0. I am running the hilschernetpi/netpi-nodered container with the new node-red 1.0.6. I have tried activating the GPIO 17 like you suggested in node-red. I get the following error “nrgpio python command not running” If I do the same setup on a raspberry PI with USB-modbus, it runs no problem. Any ideas?
Thanks