November-2nd-2018, 12:20 PM
(This post was last modified: November-2nd-2018, 02:53 PM by Armin@netPI.)
Ok Philipp, understood your problem.
Basically it seems you did everything well. I couldn't do it better. The *.pem file should never cause the NIOT Edge Gateway causing a boot failure in my opinion.
Since Edge Gateways are not supported through this forum but through Hilscher Hotline, please send your *.pem file and your inquiry to hotline@hilscher.com. They will take care of it.
One thing in addition. The edge gateway your are using is a x86 intel process based device. All netPI Docker containers will not on this Edge Gateway machine. But I agree that a registry can run on any machine, also on a Raspberry, and host ARM based and x86 based container images.
Thx
Armin
Basically it seems you did everything well. I couldn't do it better. The *.pem file should never cause the NIOT Edge Gateway causing a boot failure in my opinion.
Since Edge Gateways are not supported through this forum but through Hilscher Hotline, please send your *.pem file and your inquiry to hotline@hilscher.com. They will take care of it.
One thing in addition. The edge gateway your are using is a x86 intel process based device. All netPI Docker containers will not on this Edge Gateway machine. But I agree that a registry can run on any machine, also on a Raspberry, and host ARM based and x86 based container images.
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)