February-1st-2022, 11:26 AM
(February-1st-2022, 11:02 AM)a.w.d.m. Wrote: I'm currently trying to reset a NetPI (NIOT-E-NPI3-EN) via a USB Stick. When I uploaded a Docker image from a tar-file (size 1GB), the NetPI stopped responding to inputs and the web interface was no longer available. I then attempted to restart it by unplugging it and then plugging it in again, but the ACR light stayed off, only the POW light was on.
I have downloaded the Software image and copied the correct files to a USB 3.0-stick according to the instructions. All files and folders are in the root folder of the stick, the stick has format FAT32 and is named "RECOVERY". Unfortunately, the ACT light stays dark when I put in the stick and repower the NetPI. The stick is newly bought. The connected monitor doesn't receive any signal.
Take a look at this thread (https://forum.hilscher.com/thread-318.html #4) and specifically:
1. Make sure that you perform a full format (not quick) on the USB stick, also it would be better done on a Linux System.
2. Not every usb stick works (even if newly bought). “It needs to boot fast to get recognized by the Edge Gateway's bootloader when powered. Try out other sticks just in case”.
Regards
Azzam
