March-15th-2021, 05:48 AM
(This post was last modified: March-15th-2021, 07:07 AM by Armin@netPI.)
Well using the recovery stick can't be automated. So this procedure you need to do in any case manually.
But the rest could be done automated instead of doing it all manually using netPI' http REST API.
So you can control your netPI via http:// commands from any other local PC/notebook/station as you would do it in the browser described here https://forum.hilscher.com/thread-317.html using standard https:// commands. Setting a password ... setting network settings, enabling docker ... etc.
Once the Docker is enabled netPI supports an additional REST API of docker as described here https://forum.hilscher.com/thread-369.ht...light=rest.
So there are two REST APIs, once for netPI's basic setting and then one for Docker.
Thx
Armin
But the rest could be done automated instead of doing it all manually using netPI' http REST API.
So you can control your netPI via http:// commands from any other local PC/notebook/station as you would do it in the browser described here https://forum.hilscher.com/thread-317.html using standard https:// commands. Setting a password ... setting network settings, enabling docker ... etc.
Once the Docker is enabled netPI supports an additional REST API of docker as described here https://forum.hilscher.com/thread-369.ht...light=rest.
So there are two REST APIs, once for netPI's basic setting and then one for Docker.
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)
