November-18th-2019, 09:03 AM
I use a netPI RTE 3 as profinet client. Up to now I did use one container running NodeRed for communication and calculation. With this setup the netPI profinet client was available below 50 seconds after power on.
Now I use two containers one with NodeRed doing the communication and one with Python doing the math. With this setup it takes 210 seconds until the the profinet client is available after power on.
Could I start the container with NodeRed doing the communication first?
Is there a way to have the profinet client ready with defaults independently of running containers?
Other ideas?
Any help is appreciated
Now I use two containers one with NodeRed doing the communication and one with Python doing the math. With this setup it takes 210 seconds until the the profinet client is available after power on.
Could I start the container with NodeRed doing the communication first?
Is there a way to have the profinet client ready with defaults independently of running containers?
Other ideas?
Any help is appreciated
Code:
Hilscher NIOT-E-NPI3-51-EN-RE
Firmware version V1.1.6.0