March-13th-2019, 07:28 PM
But can you please repeat how it happened that apparently the firmware got lost?
You said your ET200S PLC was connected to netPI and was communicating. (Was netPI the only PROFINET io device connected by the way?)
Then you switched off the power of netPI? Or the PLC? Or both at the same time?
You said your ET200S PLC was connected to netPI and was communicating. (Was netPI the only PROFINET io device connected by the way?)
Then you switched off the power of netPI? Or the PLC? Or both at the same time?
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)