June-16th-2021, 02:14 AM
Dear Armin,
Could I have a dimension drawing of cover plate of the expansion slot?
Especially, I need below:
- a distance between 2 holes
- size of holes (screw pitch and diameter)
If possible, I would like to manufacture the same metal cover which NIOT-E-NPIX-XXX use.
I just modify square-cut size for a connector.
So, its dimension drawing would be also helpful for me.
Thank you very much for your support.
Best regards,
Could I have a dimension drawing of cover plate of the expansion slot?
Especially, I need below:
- a distance between 2 holes
- size of holes (screw pitch and diameter)
If possible, I would like to manufacture the same metal cover which NIOT-E-NPIX-XXX use.
I just modify square-cut size for a connector.
So, its dimension drawing would be also helpful for me.
Thank you very much for your support.
Best regards,