June-29th-2020, 08:45 PM
You need to load the container https://github.com/HilscherAutomation/ne...hernet-lan. This turns the netX controller chip into a standard TCP/IP controller. Then you can configure this interface named cifx0 like your primary port eth0.
Look to this post for example https://forum.hilscher.com/Thread-RTE3-U...-interface
or this post https://forum.hilscher.com/Thread-Modbus...ernet-Port
Look to this post for example https://forum.hilscher.com/Thread-RTE3-U...-interface
or this post https://forum.hilscher.com/Thread-Modbus...ernet-Port
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)