October-9th-2019, 08:28 AM
(This post was last modified: October-10th-2019, 12:03 PM by Armin@netPI.)
Hello Madhumati,
in this forum we talk about issue of netPI only. The netIOT Connect Gateway is not covered here.
Basically I would agree that a Docker image made for netPI should work on netIOT Connect Gateway too, but I cannot confirm it by 100%.
Based on your screen shot I see that CODESYS Windows development system does not get contact to the container via port 22. Are you sure you setup you container right in mode host network mode? Also make sure there is no other container running the same time blocking this port 22 already. If so then CODESYS container cannot run at the same time!!!.
in this forum we talk about issue of netPI only. The netIOT Connect Gateway is not covered here.
Basically I would agree that a Docker image made for netPI should work on netIOT Connect Gateway too, but I cannot confirm it by 100%.
Based on your screen shot I see that CODESYS Windows development system does not get contact to the container via port 22. Are you sure you setup you container right in mode host network mode? Also make sure there is no other container running the same time blocking this port 22 already. If so then CODESYS container cannot run at the same time!!!.
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)