I am trying to communicate netPi with the MQTT fx, but it is not communicating. MQTT flow attached, same MQTT flow working fine with Hilscher NetConnect Gateway.
(February-27th-2020, 08:04 AM)Armin@netPI Wrote: The connect gateway is not supported in the forum. Gateway Connect is only supported via Hilscher hotline team.
Thx Armin
I looked on the other MQTT topics, and I tried the same, but I get the message in the docker container console, attached screenshot & NetPi MQTT node-red flow.
February-27th-2020, 05:08 PM (This post was last modified: February-27th-2020, 10:52 PM by Armin@netPI.)
But which container are you loading? I don’t see any screen shot. Please send container start screen shot. Or do you use default software of Connect Gateway? But still this forum is not supporting this kind of device. Get in touch with hotline@hilscher.com
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)
You need to run also an MQTT Broker such as Mosquitto. There is an official Mosquitto container available on the internet I am pretty sure. You have to search on the internet. An MQTT Broker is responsible to receive data from clients such as Node-RED and to send data to all other clients that have subscribed to the same data tag name based.
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)
But I do not see setup of container in screen shot. So which container do you use? I see in your screen shot a lot of Linux commands but this is not official mosquitto container https://hub.docker.com/_/eclipse-mosquitto
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)