• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ethercat master mapping
#1
Hi,
we are developing an ethercat master based on the ComX 100 on our CN.

The dpram of the ComX 100 is seen by the HOST directly on the bus with direct parallel access, with normal reading/writing in memory.

Once sent the configuration of an ethercat network to the ComX by downloading the ENI file, the ethercat master firmware on the ComX creates the map on the input and output areas of the objects of the various nodes on the network.

Is it possible to query the ComX firmware by the HOST, through some command on the dpram, to know this mapping?

The only way we found at the moment is to export with the SYCON app the CSV file of the configuration, process its content and send it to HOST.
Other solutions?

Thanks
  Reply
#2
No support of comX in this forum. This forum is for products netPI and netHAT only. Support for comX can be received through hotline@hilscher.com, This thread will be deleted.

Thx Armin
You never fail until you stop trying.“, Albert Einstein (1879 - 1955)

  Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  NodeRed and EtherCAT Schranz 1 14 September-2nd-2019, 03:46 PM
Last Post: Armin@netPI
  EtherCAT Master: any options? maiorfi 45 446 May-30th-2019, 07:55 PM
Last Post: Armin@netPI
  Static mapping of USB-devices deme 11 71 May-15th-2019, 04:02 PM
Last Post: Armin@netPI
  [SOLVED] USB Serial device mapping into Container hannes 12 604 August-27th-2018, 04:50 PM
Last Post: Armin@netPI
  EtherCAT Slave OP mode (netPI RTE3) mauroriva 1 116 June-20th-2018, 08:38 AM
Last Post: Armin@netPI

Forum Jump:


Users browsing this thread: 1 Guest(s)