Cannot start container

[Magnus]

But before you can use the eth0 interface as a EtherCAT master with netPI RTE 3 you have to start the container with the IP parameters to activate the 2 x RJ45 RTE ports as standard ethernet interface additionally. Once this is done you can connect the container and its CODESYS runtime over the 2xRTE ports with your CODESYS Development System. Then eth0 is "free" for any use ... your EtherCAT master.

Thanks for support,

In order to - "start the container with the IP parameters"

Can I do that on an existing container or do I have to make new
container.
I saw that I can start a terminal/command-session in the container.

and

What entries and where do I make them to activate RTE as ethernet interfaces?


Best Regards

Magnus Torell