Cannot start container

[Magnus]

Thanks Armin,

I followed the link and all was fine with the container start.

I also saw some posts about a Codesys PLC as master and Ethernet interfaces.

Hmm...
My initial thought was to use the RTE ports for a master EtherCat, but
reading other posts I understand that the recommended way is to
use the "std" RPi ethernet interface for a etherCat master and instead use the
RTEs for normal ethernet traffic and development from another computer
with Codesys development.
Is that correct understood?
If so how do you install the EtherCat driver to this interface.
and activate the others for normal traffic (I think DHCP will do)
Is there a video for just the case of getting a netPI RTE as a:
- "Codesys PLC with an EtherCAT master"