May-14th-2019, 08:06 AM
Hello,
I want to mention the following points
1.) are you sure you have a DHCP running in your network?
2.) what is the status of the LED ACT of your unit?
3.) if you can connect a cable to the HDMI port ... do you see any errors there during the boot sequence? usually you see [ok] marked all in green colour
4.) please read this post https://forum.hilscher.com/Thread-DHCP-D...of-the-box . he need to use "http://NTBxxxxxxxxxx.local" in his network setup
Thx
Armin
I want to mention the following points
1.) are you sure you have a DHCP running in your network?
2.) what is the status of the LED ACT of your unit?
3.) if you can connect a cable to the HDMI port ... do you see any errors there during the boot sequence? usually you see [ok] marked all in green colour
4.) please read this post https://forum.hilscher.com/Thread-DHCP-D...of-the-box . he need to use "http://NTBxxxxxxxxxx.local" in his network setup
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)