Freshly received netPI cannot boot - Invalid partition 2

[william_lopez]

Ok I see. 

All I need is the MAC address printed on your netPI's device label (in a private message if you ant) and then I can prepare an SD card image on an FTP download server that you can download. Then you just have to unscrew the 4 netPI housing screws, undshift the two case parts, push the SD card into the slot so that it unlocks and comes out, put the SD card in an SD card reader/writer, use the tool WinDis32Image and then write the image. After finishing push the SD card back and shift the two the housing parts together and scew them tight. Pay attention that the HDMI connector is right back in the housing outlet!.

Is this an option for you?

Thx
Armin

Yes, thank you very much i'll send you a private message with the informations