January-16th-2020, 01:02 PM
Added the attachment of the breakout board again.
I also found it on your site -
https://www.hilscher.com/products/produc...edge/3003/?
You are correct, I did enable the UART and SPI modules in the Raspbarry Pi configurations.
I am using this NetPi -
https://www.hilscher.com/products/produc...-en-reecs/?
Does it support a Raspbian OS image? I see it doesn't have an SD card slot.
Thanks,
Irina.
I also found it on your site -
https://www.hilscher.com/products/produc...edge/3003/?
You are correct, I did enable the UART and SPI modules in the Raspbarry Pi configurations.
I am using this NetPi -
https://www.hilscher.com/products/produc...-en-reecs/?
Does it support a Raspbian OS image? I see it doesn't have an SD card slot.
Thanks,
Irina.