October-16th-2019, 08:17 AM
Dear,
I have tried many times to follow all instructions on how to setup a netPi RTE 3 to work as
a Codesys RTE master for etherCat, ie a PLC.
I have come so far that I am online to the device from a google chrome browser.
No it did not work with address of the network interface. I had to find the taken
DHCP ip-adress and browse to that one.
I have activated the docker service.
I have added a container and follows all instructions how to fill out the parameters,
But every time it fails when I try to start the container.
It says
ERROR
No such Image: hilschernetpi/netpi-codesys-basis
What to do??
netPI RTE 3 is new item. Portainer is version 1.12.4
Best Regards
Magnus Torell
I have tried many times to follow all instructions on how to setup a netPi RTE 3 to work as
a Codesys RTE master for etherCat, ie a PLC.
I have come so far that I am online to the device from a google chrome browser.
No it did not work with address of the network interface. I had to find the taken
DHCP ip-adress and browse to that one.
I have activated the docker service.
I have added a container and follows all instructions how to fill out the parameters,
But every time it fails when I try to start the container.
It says
ERROR
No such Image: hilschernetpi/netpi-codesys-basis
What to do??
netPI RTE 3 is new item. Portainer is version 1.12.4
Best Regards
Magnus Torell