August-8th-2018, 11:12 AM
Dear Eyad,
the source code and the container will of course run fine when using a real NIOT-E-NPIX-4DIDO module physically in your netPI.
At the current time you have no NIOT-E-NPIX-4DI4DO module in use ... so because of the missing module the software will not run 100% correct.
The NPIX-E-NPIX-4DI4DO module has 4 digital inputs and also 4 digitcal outputs. They connect to pins 15,16,22,37 for outputs and 7,8,10,11 for inputs. But additionally it supports another "internal" input pin which signals overload error coming from the bus driver chip In the module design we deliver this status information to pin 13.
Now since you have no physical module inserted the pin 13 will float and give back bad status to the node-red node. Also this problem will occur if you are using the NIOT-E-NPIX-EVA board if pin 13 is not connected. You can change the source code of the sample code yourself to fit your physical pins (the pins you want to be outputs and the pins you want to inputs) on the NIOT-E-NPIX-EVA. Then restart the container and the node-red node will show your inputs from EVA board or you can set outputs on EVA boards.
the source code and the container will of course run fine when using a real NIOT-E-NPIX-4DIDO module physically in your netPI.
At the current time you have no NIOT-E-NPIX-4DI4DO module in use ... so because of the missing module the software will not run 100% correct.
The NPIX-E-NPIX-4DI4DO module has 4 digital inputs and also 4 digitcal outputs. They connect to pins 15,16,22,37 for outputs and 7,8,10,11 for inputs. But additionally it supports another "internal" input pin which signals overload error coming from the bus driver chip In the module design we deliver this status information to pin 13.
Now since you have no physical module inserted the pin 13 will float and give back bad status to the node-red node. Also this problem will occur if you are using the NIOT-E-NPIX-EVA board if pin 13 is not connected. You can change the source code of the sample code yourself to fit your physical pins (the pins you want to be outputs and the pins you want to inputs) on the NIOT-E-NPIX-EVA. Then restart the container and the node-red node will show your inputs from EVA board or you can set outputs on EVA boards.
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)
