• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pi + netHAT + NodeRed + EtherCAT
For integrating a custom measurement device via EtherCAT, we are planning to use a Raspberry Pi equipped with netHAT.

Is there any way to have communication integrated into an existing Node-Red project, so that we can send commands and receive sensor values via EtherCAT?

Any help or suggestion is highly appreciated.
Thank you very much!
Hi there,

I am sorry to say that there is not such an integration/node for netHAT in Node-RED available.

We see netHAT as an extension device for studying our netX51 industrial network controller and since it is an embedded controller we provide just low level examples coded in C for it.

You never fail until you stop trying.“, Albert Einstein (1879 - 1955)


Possibly Related Threads…
Thread Author Replies Views Last Post
  NetHat + Ethernet/IP + APIs or SDKs michela.limaco 4 1,422 October-11th-2021, 01:05 PM
Last Post: michela.limaco
  Using Powerlink firmware with netHAT and config nxd thp9 3 4,223 August-25th-2020, 01:49 PM
Last Post: Armin@netPI
  NetHAT SPI configuration thp9 1 3,907 June-10th-2020, 02:05 PM
Last Post: Armin@netPI
  How can i set a EtherCAT node in netHAT 52-RTE? JGLee 6 5,845 June-9th-2020, 12:38 PM
Last Post: Armin@netPI
  cifX drivers EtherCAT read/write performance with NetHat over STM32 thp9 21 9,802 June-5th-2020, 10:17 AM
Last Post: Armin@netPI
  netHAT as Ethernet/IP Adapter with Codesys lstiegler 11 7,424 May-26th-2020, 06:40 PM
Last Post: Armin@netPI
  netHat configuration via config packets pitau 6 5,218 May-25th-2020, 02:21 PM
Last Post: Armin@netPI
  NetHAT temperature question thp9 1 4,407 May-14th-2020, 09:21 PM
Last Post: Armin@netPI
  Ethercat Master TwinCATversion? MGharat 1 1,975 September-19th-2019, 06:38 AM
Last Post: Armin@netPI
  Using netHAT drivers with custom linux (not Raspbian) FrankS 5 4,859 September-11th-2019, 06:16 AM
Last Post: Armin@netPI

Forum Jump:

Users browsing this thread: 1 Guest(s)