May-14th-2020, 09:09 PM
Hello,
I'm using NetHAT module with STM32MP157C-DK2 board which has a port compatible with raspberry pi shields.
After a few minutes plugging in the module, it accumulates considerable heat even though it doesn't perform anything. I don't know how to describe it but it's quiet hot.
The temperature is localized over the netx52 chip and also over the GPIO pins at a lesser extent.
The demo seems to works fine other than the fact that I got a bus error after a few seconds because I haven't configured a master yet.
Since I'm not using a RaspberryPi I was just wondering if this was normal behaviour, or could it be caused by bad gpio configuration of my board
Thanks
I'm using NetHAT module with STM32MP157C-DK2 board which has a port compatible with raspberry pi shields.
After a few minutes plugging in the module, it accumulates considerable heat even though it doesn't perform anything. I don't know how to describe it but it's quiet hot.
The temperature is localized over the netx52 chip and also over the GPIO pins at a lesser extent.
The demo seems to works fine other than the fact that I got a bus error after a few seconds because I haven't configured a master yet.
Since I'm not using a RaspberryPi I was just wondering if this was normal behaviour, or could it be caused by bad gpio configuration of my board
Thanks