December-10th-2019, 09:05 AM
Well Madhumati, all the protocols firmwares on our netX chips behave the same independent on which hardware they are used on. So even if you would look to LED description for cifX 50-RE with ECS protocol stack loaded would be fine to see how EtherCAT slave LED behaviour look like.
In your case you can visit the page for the corresponding netX chip used on netPI to get knowledge about the LED behaviour. On our knowledge base thare is a section for netX chips: here https://kb.hilscher.com/display/NETX/netX+51. I am pretty sure in this section you'll find the LED description of all protocol stacks available on netX51
In your case you can visit the page for the corresponding netX chip used on netPI to get knowledge about the LED behaviour. On our knowledge base thare is a section for netX chips: here https://kb.hilscher.com/display/NETX/netX+51. I am pretty sure in this section you'll find the LED description of all protocol stacks available on netX51
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)