April-12th-2019, 02:36 PM
Thanks for the update!
When using the following configuration:
I get these results now:
For me, it looks like something is still not right, cause the broadcast is "10.7.1.1" instead of "10.7.1.255"?
Also, I cannot find the route of the standard gateway, when checking "ip route show":
Is this missing, or do I need to check somewhere else?
Tanks,
Andi
When using the following configuration:
Code:
IP_ADDRESS 10.7.1.115
SUBNET_MASK 255.255.255.0
GATEWAY 10.7.1.1
I get these results now:
Quote:1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: cifx0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000
link/ether 00:02:a2:49:bc:f0 brd ff:ff:ff:ff:ff:ff
inet 10.7.1.115/24 brd 10.7.1.1 scope global cifx0
valid_lft forever preferred_lft forever
8: eth0@if9: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default
link/ether 02:42:ac:12:00:02 brd ff:ff:ff:ff:ff:ff link-netnsid 0
inet 172.18.0.2/16 brd 172.18.255.255 scope global eth0
valid_lft forever preferred_lft forever
For me, it looks like something is still not right, cause the broadcast is "10.7.1.1" instead of "10.7.1.255"?
Also, I cannot find the route of the standard gateway, when checking "ip route show":
Quote:default via 172.18.0.1 dev eth0
10.7.1.0/24 dev cifx0 proto kernel scope link src 10.7.1.115 linkdown
172.18.0.0/16 dev eth0 proto kernel scope link src 172.18.0.2
Is this missing, or do I need to check somewhere else?
Tanks,
Andi