March-13th-2019, 09:51 AM
Hello,
I got the following problem:
When I ended working on the NetPi yesterday everything worked fine and I had a physical connection to my fieldbus switch and I was able to run the example "PNS_simpleConfig" and connect to my PLC. After I finished working on it I shut it down.
Today when I booted it again there was not and still is not even a physical connection to my switch. No LEDs are blinking. The switch does not show a connection on its port either.
What could have gone wrong? What can I do to enable the connection again?
Removing all Containers and all images and pull and run only the programming-example container again also did not work.
best regards
I got the following problem:
When I ended working on the NetPi yesterday everything worked fine and I had a physical connection to my fieldbus switch and I was able to run the example "PNS_simpleConfig" and connect to my PLC. After I finished working on it I shut it down.
Today when I booted it again there was not and still is not even a physical connection to my switch. No LEDs are blinking. The switch does not show a connection on its port either.
What could have gone wrong? What can I do to enable the connection again?
Removing all Containers and all images and pull and run only the programming-example container again also did not work.
best regards