April-17th-2019, 03:51 PM
(April-16th-2019, 03:10 PM)Armin@netPI Wrote: That sounds weired to me. Is there a specific IP address range or setup necessary. How about testing the very same configuration with an original RPi3?
Hello Armin,
now the EtherCAT master works on eth0 if and only if the container with codesys and netx (fokkersim/netpi-codesys-netx-nodered) is deployed in host mode on the NetPi. If it is used in bridge mode the EtherCAT master does not work. Do you have any idea why this is the case? I suspect some Ethernet Packages not being forwarded properly in the docker net in bridge mode.
Codesys management, Edge Gateway Manager and NodeRed is accessed via cifx0. The remaining task is now to set up a communication between the codesys netx container and NodeRed.
Best,
Andreas