April-16th-2019, 01:54 PM
Hello Armin,
Sorry this was a misunderstanding. I referred to my repository fokkersim/netpi-codesys-netx-nodered which is now not private anymore.
Is any special reconfiguration needed for eth0 to be operated as EtherCAT master. I noticed that the mac address which is provided by ifconfig for eth0
is not the same as printed on the sticker on the device housing.
By the way I still connect to the Edge Gateway Manager via eth0.
Best,
Andreas
Sorry this was a misunderstanding. I referred to my repository fokkersim/netpi-codesys-netx-nodered which is now not private anymore.
- At the moment I can connect to the NetPI via cifx0 (RTE port) and ssh at port 22
- I can then install the CodesysControl runtime for SC devices and program the soft PLC
Is any special reconfiguration needed for eth0 to be operated as EtherCAT master. I noticed that the mac address which is provided by ifconfig for eth0
is not the same as printed on the sticker on the device housing.
By the way I still connect to the Edge Gateway Manager via eth0.
Best,
Andreas