January-20th-2023, 03:42 PM
Hi, I add on the device netIOT Edge Gateway NIOT-E-TPI51-EN-RE (Connect) V1.2.1.0 a RS485 module, NIOT-E-NPIX-RS485.
I try to use on a node-red flow but the debug shown 'FSM reset on state' and no communication is done.
I think that, in order to use this module with node-red I should modify some configuration of device and activate the /dev/ttyS0
How to configure this module?
Thanks
I try to use on a node-red flow but the debug shown 'FSM reset on state' and no communication is done.
I think that, in order to use this module with node-red I should modify some configuration of device and activate the /dev/ttyS0
How to configure this module?
Thanks