January-25th-2021, 10:42 AM
Hi Armin, before wasting hours in testing, I don't remember if I can connect via AccessPoint to the Gateway and then I can ping an instrument on the Eth0 network.
Once connected to the access point, I can ping the IP address of Eth0 but not the instrument on the same network as the Eth0 port.
Do I need to enter any rules?
Could this thing be done in both the netPI and an Edge Gateway?
Thanks.
Once connected to the access point, I can ping the IP address of Eth0 but not the instrument on the same network as the Eth0 port.
Do I need to enter any rules?
Could this thing be done in both the netPI and an Edge Gateway?
Thanks.