September-29th-2020, 09:36 AM
Dear Armin,
I need you help, please.
I'd like to separate network segments for IT and fieldbus.
For this, using netPI RTE 3, I created a container of 'hilschernetpi/netpi-netx-ethernet-lan'.
A modbus device is now connected to the fieldbus segment (RTE port).
Then, I want to output data to the modbus device using 'Modbus-Write' node with Node-RED.
But, I think 'Modbus-Write' node recognizes that TCP is the standard IT port.
Because Modbus communication doesn't start at all.
As a test, I confirmed that Modbus communication can be done properly when the modbus device is connected to the standard IT port.
Therefore, my question is:
Is it possible to make 'Modbus-Write' node recognize RTE port?
Thank you very much for your support.
Best regards,
I need you help, please.
I'd like to separate network segments for IT and fieldbus.
For this, using netPI RTE 3, I created a container of 'hilschernetpi/netpi-netx-ethernet-lan'.
A modbus device is now connected to the fieldbus segment (RTE port).
Then, I want to output data to the modbus device using 'Modbus-Write' node with Node-RED.
But, I think 'Modbus-Write' node recognizes that TCP is the standard IT port.
Because Modbus communication doesn't start at all.
As a test, I confirmed that Modbus communication can be done properly when the modbus device is connected to the standard IT port.
Therefore, my question is:
Is it possible to make 'Modbus-Write' node recognize RTE port?
Thank you very much for your support.
Best regards,