March-12th-2019, 09:27 AM
Thx Madhumati for letting us known.
I think the problem was that eth0 and wlan0 in your first case have two DHCP server settings active and hence most important two gateway addresses came alive.
This make a problem in ip addressing scheme. If two gateway addresses are active then netPI Linux system don't know where to send destination IP address to in cases the addressed IP address is not within the same subnet.
A solution for this will come at a later software version of netPI under construction that is able to configure data routing. But today this feature is not supported so you have to take care yourself to specify a single gateway only.
Thx
I think the problem was that eth0 and wlan0 in your first case have two DHCP server settings active and hence most important two gateway addresses came alive.
This make a problem in ip addressing scheme. If two gateway addresses are active then netPI Linux system don't know where to send destination IP address to in cases the addressed IP address is not within the same subnet.
A solution for this will come at a later software version of netPI under construction that is able to configure data routing. But today this feature is not supported so you have to take care yourself to specify a single gateway only.
Thx
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)
