March-7th-2019, 02:15 PM
Hello,
I downloaded the whole source code from github as zip file.
https://github.com/HilscherAutomation/ne...master.zip
Then I extracted the whole software package it with 7-zip and imported it to my TIA V15 software.
After that I found the device in the TIA portal device catalogue as usual and I was able to place device next to my PLC:
Everthing works fine as expected.
Thx
Armin
I downloaded the whole source code from github as zip file.
https://github.com/HilscherAutomation/ne...master.zip
Then I extracted the whole software package it with 7-zip and imported it to my TIA V15 software.
After that I found the device in the TIA portal device catalogue as usual and I was able to place device next to my PLC:
Everthing works fine as expected.
Thx
Armin
„You never fail until you stop trying.“, Albert Einstein (1879 - 1955)