January-4th-2019, 01:13 PM
I'm using netPI RTE with the hilschernetpi/netpi-nodered-fieldbus container installed. Now I want to activate the LED 1 an 2 (GPIO12, GPIO 13).
I try a flow with output-node Raspberry rpi gpio. But it didn`t work, below the node the message N/A is shown. Sending an e-mail using the same trigger works.
Is it even possible to access the LED with Node-Red?
I try a flow with output-node Raspberry rpi gpio. But it didn`t work, below the node the message N/A is shown. Sending an e-mail using the same trigger works.
Is it even possible to access the LED with Node-Red?