+- Hilscher Community Forum (https://forum.hilscher.com)
+-- Forum: General Infos (https://forum.hilscher.com/forum-28.html)
+--- Forum: News (https://forum.hilscher.com/forum-3.html)
+--- Thread: System software V1.2.1.0 out now! (/thread-654.html)
System software V1.2.1.0 out now! - Armin@netPI - October-25th-2020
We have uploaded today a new system software in the version V1.2.1.0 as recovery packages for your netPIs.
Here is the changelog
- Kernel patch applied "disable USB interrupt" https://lore.kernel.org/lkml/988737dbbc4e499c2faaaa4e567ba3ed8deb9a89.1581089797.git.lukas@wunner.de/
We have never seen a netPI got stuck because of this issue, but we applied the patch nevertheless
- New dialog "Proxy" in control panel under tab "Network" to configure a HTTP,HTTPS,FTP proxy
- Removed Wifi channel 14 support for region Japan which was not allowed
- Set WPA2 standard as security method in "Wifi Access Point" mode. WPA1 supported no more
- Corrected problem that the service "Wifi Access Point DHCP server" may not work after an unintended (power loss) shutdown and reboot
- Corrected problem that "Wifi Access Point DHCP server" does not work if there is no eth0 Ethernet connection is active (cable inserted) during boot times
Info about how to update your device you find there as well in the FAQ in the "For Developers" section.
ATTENTION! Applying a recovery package sets back a device to factory default and deletes all the containers installed and the settings configured. So make sure you saved all your data before executing the recovery.