• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Siemens PLC -Uploading and downloading using netPI & VPN
#21
Thanks for Support.
Can you please share screenshot for your setup- Docker bridge-network.  
My setup showing the  default showing the IP.
   



BR,
Sandip
  Reply
#22
It is the same as your screen shot shows and is 100% identical to mine since Docker automatically creates a 172.17.0.0/16 network always-
You never fail until you stop trying.“, Albert Einstein (1879 - 1955)

  Reply
#23
Now I setup and tested the same configuration as you are using.

I set my S7-1200 PLC to the IP address 192.168.253.5

   

I set my netPI eth0 to 192.168.253.1,

   

both at subnet mask 255.255.255.0.

I connected both the eth0 port and S7 PLC Ethernet port physically directly to each other.

In Tosibox container I configured static route of 192.168.253.0 subnetmask 255.255.255.0.  See here:

   

I did not conifgured any "tbnet" network for container and used standard "bridged" network as I recommended. In "bridged" mode the network will be automatically generated instead.

   

I also did not configure any S7-1200 or NL50MPI device in Tosibox, because when tunnel is establihed all IP addresses from 192.168.253.0-255 are all available on the Tosibox client.

   

This time I am using my mobile phone as internet connection for netPI. So my mobile phone is granting a hotspot to netPI over its "Wifi client" function and hence netPI gets access to the Internet. So immediately my Tosibox Client software shows connected

   

And also immediately my remote PC I installed the Tosibox client on get connected to S7-1200 PLC over the tunnel

   

This all took me 7-8 minutes of time.
You never fail until you stop trying.“, Albert Einstein (1879 - 1955)

  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Profinet to Siemens PLC j.langlois 4 3,503 January-26th-2021, 06:11 PM
Last Post: j.langlois
  Detecting NetPI in Siemens TIA via Profinet andrewc 3 3,791 April-11th-2019, 06:42 PM
Last Post: Armin@netPI

Forum Jump:


Users browsing this thread: 1 Guest(s)